Invotel SX8200 Manuel d'utilisateur télécharger pdf

Music-On-Hold Adapter Installation

Two Line

Model # SX8200

Rev 25

• Plug the included AC adapter. (110V AC to 12V AC)

• Confirm that all 2 LED lights on this unit are BLINKING

• Connect “PHONE LINES” jacks to your “Wall” Jacks using the provided cord

• Observe that as you connect the wall jacks the blinking lights turn OFF

(on non

existing lines the lights keep blinking and that is OK)

•

• •

• You may use a splitter (T adapter) at the Wall jack to connect both this device

and the telephone. If you do not have a splitter use the “TELEPHONE” jacks

on this device to plug the telephone (use Telephone “L1/ L2 ” and/or

Telephone “L2 “ to plug your telephone in). Please note that just one

telephone is optionally connected to this device, other telephones remain

connected to their own wall jacks.

• Plug one end of the audio cable into the RCA AUDIO IN jack on the SX8200,

plug the other end of cable into the audio out jack of your audio source such as

the connector on digital player (8 ohm or 600 ohm -preferred), Radio, CD player,

PC sound card speaker output, etc. We recommend you to set the volume on

your audio source to mid level.

(please note some music titles are not royalty-free and you may want to use the royalty-

free music titles to avoid annual licensing payments to ASCAP and BMI for playing those

titles on-hold)

IN L2 L1/ L2 L2 L1/ L2 12VAC

TELEPHONE PHONE LINES 600ma

WALL

JACK

PHONE

WALL

JACK

PHONE

110 V

AUDIO

TEST

Problems Possible Cause / Solution

Innovative Telecommunication Technology LLC

1112 Montana Ave Suite 250 Santa Monica, CA 90403 USA

Toll-Free: 800-747-0708 Tel: 310-899-0078 Fax: 310-230-5346

10.

Hold Music activates in

a conference call or

when two phones pick

up at same time

•

If for any reason the hold music is activated

inadvertently, it can always be deactivated by pressing

the FLASH button in any setting.

•

Conference calls can be done a better way: Press

FLASH, you will get a dial-tone now dial the phone

number of the 2

party then press FLASH to join the

two calls together.

L1 L2

L2 (if any) L1/ L2

6. MOH works but audio

does not stop when call

is picked up in A1 or A3

settings.

• Wire distance to adapter is too long, Centralize the

location of device to be as close as possible to all the

phones. Try the A2 setting.

• If you are re-wiring “daisy chain” wiring works better than

” star” or “home run” or Independent wiring

• Press FLASH button to stop the music.

7. Some Phones work ,

some do not

•

All your phones need to be similar model for activation

in A1...A3 settings. If you mix different phone models,

Use the B1, B2 settings or Voice Activation in C1,

C2 settings. Refer to pages 4 or 5 for more details.

8. Randomly Hold music

starts to play by it self

or does not activate in

A1, A2 or A3 settings

•

The call needs to be on Hold min. 2 sec. before you

may pick it up.

•

When you hang up, wait 2 seconds before selecting

the same line again.

•

Check for extra devices sharing that line like Message

indicator, Answering machine, Alarm system, Modem

etc. Use a “privacy module” between the line and that

extra device to keep them off the line when line is

being used by your phone.

•

Set your Alarm system and/or your DSL line to share

FAX line.

•

Excessive wiring- Total wire length per line must be

under 500 feet ( Ex: if you have 9 wall jacks -no matter

spare or a phone plugged in- each connected via a

100 foot wire to a common point then your total wire

length is 9 x 100=900 feet )

•

Use FLASH button to deactivate music.

9. Audio shuts off or

flickers

•

Extensive audio volume. Lower the volume to proper

level.

AUDIO

A B C 1 2 3

1 2 3 4

Résumé du contenu

Page 1 -

Music-On-Hold Adapter InstallationTwo LineModel # SX8200 Rev 25• Plug the included AC adapter. (110V AC to 12V AC)• Confirm that all 2 LED lig

Page 2 - Trouble Shooting:

iiIMPORTANT NOTE: The audio may activate in the middle of a call due tofactors like excessive wiring (see page 8 item 8), bad or old wiring , existing

Page 3 - Warranty

iiiOther settings:for GE 2-9487GE2-A , GE 2-9488GE2-A and RCA 25403 phones use theB3 setting and follow the instructions on page 3 it should work by

Page 4

ivOperation in B1, B2 settings: To activate: press thenTo deactivate just re-select that line and pressVoice Deactivation: if the

Modèles reliés SX8400

Commentaires sur ces manuels

Pas de commentaire

Invotel SX8200 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Audio Invotel SX8200. Invotel SX8200 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés SX8400

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Invotel SX8200